oK.. Erich is going to try and contact him either by end of this week or next.. his Army job is doing some training and kinda taking up his time hehe.
Now last time the price of the molds was incorporated into costs I think.. we paid $20 each plus shipping. But, until we get info from him, we can't say for sure if they will cost less or not. So, I say.. for NOW.. figure them at least at 20 for now.
IF he will make them again.. we will get a price quote plus shipping and do like last time. Just remember.. the last time the process started in August and we didn't get them till November. So don't expect them fast if he can do it.
For those of you new to the forums who have asked about them.. they are stainless steel or bronze.. They measure approx 2" across. I have pictures posted on these forums.
Here are some
http://www.ranger.budgetauthenticity.or ... r+broaches
Front and back so you can see the hole/loop he made so one can run a pin or a cord through them.